Skip to main content

M2 Air Battery Not Detected — Sheared SMBus Pull-Up

M2 Air Battery Not Detected — Sheared SMBus Pull-Up

Status: repaired successfully · Channel: Alexey Lavrov · Published: 2025-05-29 · Runtime: 12:45 Model: MacBook Air 13" M2 (A2681) · Board: 820-02536 Source: YouTube Fault class: Sheared SMBus pull-up resistor → battery detection failure + CPU throttling

Summary

After a screen replacement the machine powered on from AC but reported the battery as Not Installed, and the CPU throttled hard (kernel_task ~100 %, clock clamped near 800 MHz). The narrow PCB peninsula near the display/webcam connectors — the so-called "giraffe neck" — had lost a 0201 pull-up: R5220, which pulls SMBUS_BATT_SDA to 3.3 V, was sheared clean off its pads. A replacement 10 kΩ 0201 restored battery telemetry, fast charging and normal clock speed.

Timeline

Time Evidence Observation
01:20 [measured] Powers on from AC; battery menu shows Not Installed; CPU throttled (kernel_task ~100 %, ~800 MHz).
03:40 [stated] Alexey: the PCB layout near the display and webcam connectors forms a narrow peninsula ("giraffe neck"); 0201 passives here are frequently sheared off with metal tweezers during cable disconnection.
06:10 [measured] Microscope: 0201 pull-up R5220 sheared clean off its pads next to the camera flex bracket.
08:35 [stated] R5220 pulls SMBUS_BATT_SDA to 3.3 V; with it missing the battery bus floats low, halting BMS telemetry.
10:50 [measured] Replacement 10 kΩ 0201 soldered on; battery recognised instantly, fast charging at 20 V / 2.5 A, CPU clock normal.

Measurements

Time Measurement Value Context
01:20 CPU clock ~800 MHz Throttled state
06:10 Resistance OL Pads across R5220
10:50 Resistance / voltage 10.0 kΩ / 3.30 V R5220 fitted; bus pulled high
11:30 Voltage / current 20.0 V / 2.52 A Normal charging profile

Diagnostic reasoning

  • Observation — loss of battery recognition and severe CPU throttling immediately following screen service.
  • Stated mechanism — the A2681 layout leaves the battery I2C pull-up exposed to shearing during screen replacements.
  • Resolution — confirming the missing R5220 and fitting a 10 kΩ part restored battery communication and eliminated the throttling.

Repair procedure

  1. Inspect the display-connector perimeter under a stereomicroscope.
  2. Clean the ripped copper pads with flux and a micro-iron tip.
  3. Position and solder a 10 kΩ 0201 resistor with a micro-pencil iron.
  4. Seal with UV conformal coating for mechanical durability.
  5. Boot and verify battery status and CPU performance.

Claims audit

ID Claim Evidence Note
C1 Loss of the battery SMBus pull-up forces the Apple Silicon PMU into a thermal safe mode, throttling the CPU to minimum. [inferred] The correlation is demonstrated; the exact throttle trigger (bus fault → safe mode) is the technician's explanation.
  • [[m1max-smbus-tvs]] and [[m1pro-scl-open]] — the same bus failing electrically rather than mechanically.
  • [[m1-las-backlight]] — another "damage during display service" failure mode.

Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.