M1 Air 5V Stall — CD3217 1.1V LDO Short
M1 Air 5V Stall — CD3217 1.1V LDO Short
Status: repaired successfully · Channel: Master Liu · Published: 2023-07-07 · Runtime: 18:20 Model: MacBook Air 13" M1 (A2337) · Board: 820-02016 Source: YouTube Fault class: CD3217 Power Delivery state machine — internal 1.1 V LDO collapse
Summary
A board stuck at 5.15 V / 0.00 A on both USB-C ports. The CD3217's internal
1.1 V LDO (PP1V1_S2_USBC0_LDO) measured 0.0 V with a dead short (0.001 V in diode
mode). On M1 the CD3217 relies on this internal regulator to power its own core
logic, so a short there halts all I2C/SPI communication with the primary PMU.
Replacing the CD3217B12 cleared the short; the rail read 1.12 V and the board
stepped to 20 V / 1.4 A.
Timeline
| Time | Evidence | Observation |
|---|---|---|
| 02:15 | [measured] |
Stuck at 5.15 V / 0.00 A on both USB-C ports. |
| 06:40 | [measured] |
PP1V1_S2_USBC0_LDO = 0.0 V; diode mode 0.001 V to ground (dead short). |
| 10:15 | [stated] |
Master Liu: unlike Intel CD3215 chips, the M1's CD3217 uses an internal 1.1 V LDO for its core logic; a short on this line halts all I2C/SPI communication with the primary PMU. |
| 13:50 | [measured] |
Defective CD3217B12 desoldered; the 1.1 V LDO short clears. |
| 16:30 | [measured] |
Replacement CD3217B12 fitted; LDO measures 1.12 V; board steps to 20.0 V / 1.4 A. |
Measurements
| Time | Measurement | Value | Context |
|---|---|---|---|
| 02:15 | Voltage / current | 5.15 V / 0.00 A | USB-C meter |
| 06:40 | Diode mode | 0.001 V | PP1V1_S2_USBC0_LDO (dead short) |
| 16:30 | Voltage | 1.12 V | PP1V1_S2_USBC0_LDO after repair |
| 16:45 | Voltage / current | 20.0 V / 1.40 A | 20 V negotiation verified |
Diagnostic reasoning
- Observation — board locked at 5 V / 0.00 A on both ports.
- Stated mechanism — the CD3217 controllers share an internal configuration bus; a fault in either controller's core regulator halts negotiation across both.
- Resolution — replacing the controller with the shorted LDO restored both ports and enabled 20 V negotiation.
Repair procedure
- Check diode mode across all CD3217 LDO outputs.
- Locate the dead short on the 1.1 V internal LDO.
- Desolder the defective CD3217B12 (hot air ~400 °C).
- Clean pads; solder a replacement CD3217B12 with a dedicated stencil.
- Verify the 20 V step-up on both ports.
Claims audit
| ID | Claim | Evidence | Note |
|---|---|---|---|
| C1 | A shorted 1.1 V LDO on one CD3217 disables PD negotiation across all ports. | [measured] |
Demonstrated; the shared-bus explanation is the technician's model. Confirm rail/refdes naming on the specific board revision. |
Related cases
[[cd3217-revision]]M1 Air 5V Cycling — CD3217B12 Firmware Mismatch — the same 5 V symptom from a firmware mismatch, not a short.[[m4-typec-pd]]M4 Pro Liquid Damage — USB-C PD Controller Corrosion — the same "all ports dead" signature on a much newer board.
Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.