Skip to main content

M1 Air 5V Stall — CD3217 1.1V LDO Short

M1 Air 5V Stall — CD3217 1.1V LDO Short

Status: repaired successfully · Channel: Master Liu · Published: 2023-07-07 · Runtime: 18:20 Model: MacBook Air 13" M1 (A2337) · Board: 820-02016 Source: YouTube Fault class: CD3217 Power Delivery state machine — internal 1.1 V LDO collapse

Summary

A board stuck at 5.15 V / 0.00 A on both USB-C ports. The CD3217's internal 1.1 V LDO (PP1V1_S2_USBC0_LDO) measured 0.0 V with a dead short (0.001 V in diode mode). On M1 the CD3217 relies on this internal regulator to power its own core logic, so a short there halts all I2C/SPI communication with the primary PMU. Replacing the CD3217B12 cleared the short; the rail read 1.12 V and the board stepped to 20 V / 1.4 A.

Timeline

Time Evidence Observation
02:15 [measured] Stuck at 5.15 V / 0.00 A on both USB-C ports.
06:40 [measured] PP1V1_S2_USBC0_LDO = 0.0 V; diode mode 0.001 V to ground (dead short).
10:15 [stated] Master Liu: unlike Intel CD3215 chips, the M1's CD3217 uses an internal 1.1 V LDO for its core logic; a short on this line halts all I2C/SPI communication with the primary PMU.
13:50 [measured] Defective CD3217B12 desoldered; the 1.1 V LDO short clears.
16:30 [measured] Replacement CD3217B12 fitted; LDO measures 1.12 V; board steps to 20.0 V / 1.4 A.

Measurements

Time Measurement Value Context
02:15 Voltage / current 5.15 V / 0.00 A USB-C meter
06:40 Diode mode 0.001 V PP1V1_S2_USBC0_LDO (dead short)
16:30 Voltage 1.12 V PP1V1_S2_USBC0_LDO after repair
16:45 Voltage / current 20.0 V / 1.40 A 20 V negotiation verified

Diagnostic reasoning

  • Observation — board locked at 5 V / 0.00 A on both ports.
  • Stated mechanism — the CD3217 controllers share an internal configuration bus; a fault in either controller's core regulator halts negotiation across both.
  • Resolution — replacing the controller with the shorted LDO restored both ports and enabled 20 V negotiation.

Repair procedure

  1. Check diode mode across all CD3217 LDO outputs.
  2. Locate the dead short on the 1.1 V internal LDO.
  3. Desolder the defective CD3217B12 (hot air ~400 °C).
  4. Clean pads; solder a replacement CD3217B12 with a dedicated stencil.
  5. Verify the 20 V step-up on both ports.

Claims audit

ID Claim Evidence Note
C1 A shorted 1.1 V LDO on one CD3217 disables PD negotiation across all ports. [measured] Demonstrated; the shared-bus explanation is the technician's model. Confirm rail/refdes naming on the specific board revision.
  • [[cd3217-revision]] — the same 5 V symptom from a firmware mismatch, not a short.
  • [[m4-typec-pd]] — the same "all ports dead" signature on a much newer board.

Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.