Skip to main content

M1 Air 5V Cycling — CD3217B12 Firmware Mismatch

M1 Air 5V Cycling — CD3217B12 Firmware Mismatch

Status: repaired successfully · Channel: iBoff RCC · Published: 2023-12-31 · Runtime: 28:40 Model: MacBook Air 13" M1 (A2337) · Board: 820-02016 Source: YouTube Fault class: CD3217B12 silicon-revision mismatch / master–slave bus stall

Summary

Part of a seven-board batch. Board #3 drew 5.1 V, cycling between 0.05 A and 0.25 A without ever completing 20 V negotiation. Scoping the shared CD3217 I2C bus showed data traffic freezing mid-frame. The technician's rule: replacement CD3217 chips must match the exact B12 silicon revision — older/incompatible revisions cause a firmware mismatch that the PMU answers by resetting the bus. Fitting a known-good CD3217B12 produced clean I2C traffic and a full 20 V / 1.45 A boot.

Timeline

Time Evidence Observation
07:10 [measured] Board #3 draws 5.1 V, cycling 0.05–0.25 A every few seconds; 20 V negotiation never completes.
12:40 [measured] Oscilloscope on the shared CD3217 I2C bus: data traffic freezes mid-frame.
16:15 [stated] iBoff technician: replacement CD3217 chips must match the exact silicon revision (B12); older C00 or incompatible revisions cause firmware-mismatch lockouts during PMU initialisation.
20:30 [measured] Previously fitted replacement removed; known-good CD3217B12 installed; scope shows clean, sustained I2C transactions.
24:15 [measured] Board negotiates 20.1 V / 1.45 A; macOS boots to the login screen.

Measurements

Time Measurement Value Context
07:10 Voltage / current 5.1 V / 0.05–0.25 A cycling Input meter, board #3
12:40 Bus waveform Incomplete / truncated pulses Shared I2C data bus
24:15 Voltage / current 20.1 V / 1.45 A Booted into macOS

Diagnostic reasoning

  • Observation — negotiates 5 V but power-cycles continuously; I2C traffic aborts mid-frame.
  • Stated mechanism — the PMU loads configuration profiles into the CD3217 controllers at boot; an incompatible silicon revision produces a checksum mismatch, prompting a bus reset.
  • Resolution — installing a verified B12 revision resolved the communication errors and allowed the 20 V contract to complete.

Repair procedure

  1. Diagnose bus cycling on the scope (I2C clock and data).
  2. Remove the mismatched CD3217 controller.
  3. Pre-tin pads with low-melt solder, then leaded solder wick.
  4. Solder a verified CD3217B12 with hot air.
  5. Confirm stable I2C communication and boot.

Claims audit

ID Claim Evidence Note
C1 CD3217 controllers require matched B12 silicon revisions; incompatible variants produce an unresolvable 5 V cycling loop. [stated] Consistent with the observed fix, but the revision-matching rule is the technician's; verify against Apple's documented part/revision matrix rather than assuming B12 universally.
  • [[cd3217-ldo]] — the same 5 V symptom from a shorted LDO rather than firmware.
  • [[m4-typec-pd]] — PD controller faults on newer silicon.

Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.