M1 Air 5V Cycling — CD3217B12 Firmware Mismatch
M1 Air 5V Cycling — CD3217B12 Firmware Mismatch
Status: repaired successfully · Channel: iBoff RCC · Published: 2023-12-31 · Runtime: 28:40 Model: MacBook Air 13" M1 (A2337) · Board: 820-02016 Source: YouTube Fault class: CD3217B12 silicon-revision mismatch / master–slave bus stall
Summary
Part of a seven-board batch. Board #3 drew 5.1 V, cycling between 0.05 A and 0.25 A without ever completing 20 V negotiation. Scoping the shared CD3217 I2C bus showed data traffic freezing mid-frame. The technician's rule: replacement CD3217 chips must match the exact B12 silicon revision — older/incompatible revisions cause a firmware mismatch that the PMU answers by resetting the bus. Fitting a known-good CD3217B12 produced clean I2C traffic and a full 20 V / 1.45 A boot.
Timeline
| Time | Evidence | Observation |
|---|---|---|
| 07:10 | [measured] |
Board #3 draws 5.1 V, cycling 0.05–0.25 A every few seconds; 20 V negotiation never completes. |
| 12:40 | [measured] |
Oscilloscope on the shared CD3217 I2C bus: data traffic freezes mid-frame. |
| 16:15 | [stated] |
iBoff technician: replacement CD3217 chips must match the exact silicon revision (B12); older C00 or incompatible revisions cause firmware-mismatch lockouts during PMU initialisation. |
| 20:30 | [measured] |
Previously fitted replacement removed; known-good CD3217B12 installed; scope shows clean, sustained I2C transactions. |
| 24:15 | [measured] |
Board negotiates 20.1 V / 1.45 A; macOS boots to the login screen. |
Measurements
| Time | Measurement | Value | Context |
|---|---|---|---|
| 07:10 | Voltage / current | 5.1 V / 0.05–0.25 A cycling | Input meter, board #3 |
| 12:40 | Bus waveform | Incomplete / truncated pulses | Shared I2C data bus |
| 24:15 | Voltage / current | 20.1 V / 1.45 A | Booted into macOS |
Diagnostic reasoning
- Observation — negotiates 5 V but power-cycles continuously; I2C traffic aborts mid-frame.
- Stated mechanism — the PMU loads configuration profiles into the CD3217 controllers at boot; an incompatible silicon revision produces a checksum mismatch, prompting a bus reset.
- Resolution — installing a verified B12 revision resolved the communication errors and allowed the 20 V contract to complete.
Repair procedure
- Diagnose bus cycling on the scope (I2C clock and data).
- Remove the mismatched CD3217 controller.
- Pre-tin pads with low-melt solder, then leaded solder wick.
- Solder a verified CD3217B12 with hot air.
- Confirm stable I2C communication and boot.
Claims audit
| ID | Claim | Evidence | Note |
|---|---|---|---|
| C1 | CD3217 controllers require matched B12 silicon revisions; incompatible variants produce an unresolvable 5 V cycling loop. | [stated] |
Consistent with the observed fix, but the revision-matching rule is the technician's; verify against Apple's documented part/revision matrix rather than assuming B12 universally. |
Related cases
- [[cd3217-ldo]] — the same 5 V symptom from a shorted LDO rather than firmware.
- [[m4-typec-pd]] — PD controller faults on newer silicon.
Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.