Apple Silicon DFU Revive Loop — Inductor Solder Fatigue
Apple Silicon DFU Revive Loop — Inductor Solder Fatigue
Status: repaired successfully · Channel: Alexey Lavrov (WIKI#02) · Published: 2025-06-18 · Runtime: 24:18 Model: Apple Silicon M1/M2 platforms (A2337 / A2338) · Board: 820-02016 Source: YouTube Fault class: Solder fatigue on a secondary power inductor causing a DFU revive failure
Summary
The machine booted only to DFU, and Apple Configurator's Revive failed at ~75 %
with error 75 / host disconnection. Stage 2 of the revive powers up higher SoC
logic rails; scoping PP1V2_AWAKE at inductor L5800 showed the rail collapsing
1.2 V → 0.0 V during the flash handshake. A microscopic stress crack in the solder
fillet on L5800's switch-node terminal was the cause. Reflowing the terminal let
the revive complete — user data fully preserved.
Timeline
| Time | Evidence | Observation |
|---|---|---|
| 02:00 | [measured] |
Boots only to DFU; Configurator Revive fails at ~75 % (error 75 / host disconnection). |
| 06:40 | [stated] |
Alexey: Stage 2 powers up higher-level SoC rails; if a rail drops out under this dynamic load, the SoC resets and corrupts the write. |
| 11:15 | [measured] |
Oscilloscope on PP1V2_AWAKE inductor L5800: voltage collapses 1.2 V → 0.0 V during the flash handshake. |
| 16:30 | [measured] |
High-magnification inspection shows a microscopic stress crack in the solder fillet on L5800's switch-node terminal. |
| 21:40 | [measured] |
Terminal resoldered with leaded solder; revive completes without error; device boots with user data preserved. |
Measurements
| Time | Measurement | Value | Context |
|---|---|---|---|
| 11:15 | Voltage transient | 1.2 V → 0.0 V collapse | PP1V2_AWAKE on the scope |
| 21:40 | Progress | 100 % success | Configurator revive |
Diagnostic reasoning
- Observation — the revive fails at the same point every time during flash verification.
- Stated mechanism — software/firmware restores depend on stable hardware power supplies; a failing secondary rail can mimic flash-memory failure.
- Demonstration — scoping captured an active dropout on
PP1V2_AWAKEfrom a cracked inductor joint; reflowing stabilised the rail and the revive finished.
Repair procedure
- Monitor secondary power inductors with an oscilloscope during the DFU process.
- Identify the rail that drops out.
- Inspect the inductor solder fillets under the microscope.
- Reflow the switch-node and output pads with leaded solder and flux.
- Run the non-destructive DFU revive from a host Mac.
Claims audit
| ID | Claim | Evidence | Note |
|---|---|---|---|
| C1 | Revive preserves user data; Restore wipes keys. | [stated] |
Correct as a general rule, but confirm before relying on it for a customer's data. |
| C2 | Revive failures are frequently hardware-induced rail dropouts, not software corruption. | [inferred] |
Strongly demonstrated here — worth scoping rails before re-flashing repeatedly. |
Related cases
- [[m1-pmu-firmware]] — the converse: a hardware fix that still needed a revive.
- [[m1pro-soft-short]] — rail integrity problems that only show under load.
Provenance: condensed from the video's audio transcript (Google AI Studio); timestamps, refdes and values are as stated in the video and are not independently verified.